So the old tank hood I had broke So I built a new one! I used 1/16" plexi glass and some old trim from my house when we put in wood flooring.
I also put some pieces of small trim on top and glued them on with aquarium safe seal so it wouldn't hurt the fish. The pieces on top hold the fish food and the light on top for the light hood!
Let me know what you think!
BEFORE
AFTER
Fahakas are like dogs! They come up to you and say hi! Or they're just looking for food!
When new! ~April 1st
Most Recent Aug 1st
My Puffers: 1 GSP (Microfiche) RIP, 1 Monotrete Turgidus (Leon) in a 30gal. 1 Monotrete suvattii in a 40 gal FW. 120 gallon BW with 3 juvenile Dragon Gobies (so cool). 55 gal with a 2" GSP named Hank. 180 gallon being set up for a Fahaka in the next few months!
Not going to do too well. I tried plex with my SW tank and the heat from the lights warped and burned the plex through. That was 3/8 inch impact resistant too. You can go get a few pieces of tempered 1/4 inch for about $75 from a good glass place.
"Darwin swings...annnnnnd a miss. Boy Jim, Chuck's suffered at the plate tonight. He's 0 for 3 and I'm not sure he's recovered from that shoulder pull a few weeks ago. I'll bet the front office is re-thinking that contract."
Definitely not sturdy, but if it gets the job done...
I just order custom-cut cell-cast acrylic sheets from popdisplays on eBay. They hold up well as replacement panels. Although acrylic is lightweight and doesn't really break, I will always prefer glass since it is so difficult to scratch, and to me, looks better.
It's a crayfish! It's a snail! It's a... ah who cares?
Nom nom nom!...
Tank: 4 liter custom-shaped sphere
Contents: 1 Brainfish
Ph: 7.4
Ammonia, nitrites, nitrates: ?
Problem: Cloudy/muddy water
Can you help me?