puffer tank

FrogSplash · Post by **FrogSplash** » Tue May 17, 2011 3:56 pm

Here is my current fang puffer tank, but i will be trading it (the puffer), not for a congo puffer after all but a few neon blue rams =P

Post by **Pufferpunk** » Tue May 17, 2011 4:17 pm

Better to have made your substrate 1" or less.

FrogSplash · Post by **FrogSplash** » Tue May 17, 2011 4:31 pm

yeah i overdid it a little. it was a bad estimation on my part

Post by **Pufferpunk** » Tue May 17, 2011 5:04 pm

Way more upkeep with that.

FrogSplash · Post by **FrogSplash** » Tue May 17, 2011 5:15 pm

I dont mind. i sold off the last of my frogs, so i only have two active projects, this tank and my main. aquarium maintenance is a lot easier imo than for snakes, scorpions, geckos and frogs

Post by **Pufferpunk** » Tue May 17, 2011 5:17 pm

Why not just thin it out a bit, like to 1"?

FrogSplash · Post by **FrogSplash** » Tue May 17, 2011 5:20 pm

cause its all set up and planted and i like the way it looks. plus, the front is higher up than the rear is, my fault for not making it even. but the only changes im making are the fish, if and when that comes to happen

The Puffer Forum

The Puffer Store

puffer tank

puffer tank

Re: puffer tank

Re: puffer tank

Re: puffer tank

Re: puffer tank

Re: puffer tank

Re: puffer tank