Stress Coat+ and Ammonia

A place to discuss general puffer care or news.
User avatar
liquid88
Figure 8 Puffer
Posts: 163
Joined: Thu Feb 12, 2009 2:43 pm

Stress Coat+ and Ammonia

Post by liquid88 »

Hey all,

My 29 Gal. recently sprung a leak while it was cycling. It was SOOO close to finishing up. I returned it and got a new one...(hopefully this 1 will be of better quality!) Washed it out, cleaned the gravel, set up the filter & heaters blah blah(rinse, lather, repeat). I added API Stress Coat+ to the (chlorinated) water in the new tank, Set the heater to 80 and started adding ammonia about an hour later to start the fishless cycle...AGAIN!! On the last tank I used about 80 drops(5ml) initially to get the tank to read 2-4ppm on the API Master tesk kit, then 40 drops daily after I got a reading on the nitrite. I was using Tetra Aquasafe at the time. This time around it took about 35ml of ammonia to get the tank to read...i'm guessing 5-6 ppm (There is no specified color for 5ppm but it was darker than 4 and much lighter than 8ppm). That was around 1am today...tested again at 12 noon and the test read somewhere between 1-2 ppm with absoloutly no seed material in the tank. This is ridiculous lol at this rate I'm never going to be able to finish cycling this tank. It says on the bottle that it removes chlorine, chloramines and ammonia in tap water but jeez! 35ml of ammonia and about 12 hours later it's still working?


Any suggestions guys & gals?
User avatar
marksrush
Fahaka Puffer
Posts: 856
Joined: Sat Sep 13, 2008 8:10 pm
Gender: Male
My Puffers: One GSP.
Location (country): USA
Location: Raymore, Missouri USA

Re: Stress Coat+ and Ammonia

Post by marksrush »

Wow, bad luck, sorry to hear it. Leaks really suck.

I'm no expert, but I was thinking you would've wanted to save your gravel, and just transfer it over to the new tank - so what bacteria you did have in there would be preserved. Same with the heater and filter...if the tank was as close to being fully cycled as you say, there would've likely been more bacteria on the surfaces of all that equipment...it might have saved you some time with the cycle process.

Some people are against this sort of thing, but there's always Tetra SafeStart (freshwater) or Bio-Spira (marine), most people report good things about them.
User avatar
LilGreenPuffer
Former Staff Member
Posts: 5301
Joined: Sun Jan 25, 2009 11:26 pm
Gender: Female
My Puffers: Dwarf puffer - Thumbelina (only mine in my heart now; she lives in CT with my friend)

RIP Inigo Montoya, Fezzik, and Vizinni.
RIP James Bond.
Location (country): United States
Location: Kentucky

Re: Stress Coat+ and Ammonia

Post by LilGreenPuffer »

If you use products that remove ammonia/nitrites/nitrates, then that would impede the process, right? Marksrush is right; if you ever have to do that again, def. don't clean everything; just stick it all in there. With luck, you could restart the cycle from where it stopped in the old one.
"I will give you a talisman. Whenever you are in doubt, or when the self becomes too much with you, apply the following test. Recall the face of the poorest and the weakest man whom you may have seen, and ask yourself, if the step you contemplate is going to be of any use to him or her. Will she gain anything by it? Will it restore her to a control over her own life and destiny? In other words, will it lead to freedom for the hungry and spiritually starving millions? Then you will find your doubts and your self melt away."

Found among the papers of Mohatma Gandhi


Image

Come and visit http://www.thetriopsforum.com!

I AM A DUDETTE!

NEED NITRIFYING BACTERIA FOR YOUR NEW TANK? PM ME!
User avatar
liquid88
Figure 8 Puffer
Posts: 163
Joined: Thu Feb 12, 2009 2:43 pm

Re: Stress Coat+ and Ammonia

Post by liquid88 »

That's right...I forgot to mention I didn't "clean" everything. I just rinsed out the new tank...gave the old gravel a quick rinse and didn't touch the old rocks/plants/heater/filter (kept the plants and rocks in a bucket of old tank water). The ammonia is stable now at 4-5 ppm but I have noticed some things...the bubbles that were all over the tank when I frist set it up are completely gone and I can already feel some sort of "slime" starting to form on some parts of the glass.
The problem now is that my heater just died...I'm now using two of those Walmart plastic automatic heaters that are only heat to around 76-78 degrees. Current tank temp is around 77. I just ordered a Visi Therm Stealth 150 from eBay at a surprisingly good price. Hope it comes in soon because I know this is gonna set me back at least a few days.
User avatar
LilGreenPuffer
Former Staff Member
Posts: 5301
Joined: Sun Jan 25, 2009 11:26 pm
Gender: Female
My Puffers: Dwarf puffer - Thumbelina (only mine in my heart now; she lives in CT with my friend)

RIP Inigo Montoya, Fezzik, and Vizinni.
RIP James Bond.
Location (country): United States
Location: Kentucky

Re: Stress Coat+ and Ammonia

Post by LilGreenPuffer »

When I was cycling, I put a regular incandescent bulb into a desk lamp, which kept it at about 82.
"I will give you a talisman. Whenever you are in doubt, or when the self becomes too much with you, apply the following test. Recall the face of the poorest and the weakest man whom you may have seen, and ask yourself, if the step you contemplate is going to be of any use to him or her. Will she gain anything by it? Will it restore her to a control over her own life and destiny? In other words, will it lead to freedom for the hungry and spiritually starving millions? Then you will find your doubts and your self melt away."

Found among the papers of Mohatma Gandhi


Image

Come and visit http://www.thetriopsforum.com!

I AM A DUDETTE!

NEED NITRIFYING BACTERIA FOR YOUR NEW TANK? PM ME!
User avatar
liquid88
Figure 8 Puffer
Posts: 163
Joined: Thu Feb 12, 2009 2:43 pm

Re: Stress Coat+ and Ammonia

Post by liquid88 »

No incandescent bulbs here...heater is scheduled to arrive on tuesday. I have a mature 10 gallon freshwater tank with a few plants in it...about 1/2 inch of gravel. I would use it as seed material but the tank has nematodes...would these affect a puffer (looking to get a Figure 8 ).
User avatar
LilGreenPuffer
Former Staff Member
Posts: 5301
Joined: Sun Jan 25, 2009 11:26 pm
Gender: Female
My Puffers: Dwarf puffer - Thumbelina (only mine in my heart now; she lives in CT with my friend)

RIP Inigo Montoya, Fezzik, and Vizinni.
RIP James Bond.
Location (country): United States
Location: Kentucky

Re: Stress Coat+ and Ammonia

Post by LilGreenPuffer »

Nematodes very definitely would.
"I will give you a talisman. Whenever you are in doubt, or when the self becomes too much with you, apply the following test. Recall the face of the poorest and the weakest man whom you may have seen, and ask yourself, if the step you contemplate is going to be of any use to him or her. Will she gain anything by it? Will it restore her to a control over her own life and destiny? In other words, will it lead to freedom for the hungry and spiritually starving millions? Then you will find your doubts and your self melt away."

Found among the papers of Mohatma Gandhi


Image

Come and visit http://www.thetriopsforum.com!

I AM A DUDETTE!

NEED NITRIFYING BACTERIA FOR YOUR NEW TANK? PM ME!
User avatar
edmlfc1
Mbu Puffer
Posts: 2011
Joined: Sun Sep 09, 2007 5:03 pm
My Puffers: Elvis (Stars & Stripes) R.I.P. 9/11/11
125G:Fahaka (Annabelle)
Location (country): U.S.A.
Location: Texas

Re: Stress Coat+ and Ammonia

Post by edmlfc1 »

If you didn't clean the gravel or the filter then you have bacteria in your tank and that is what's causing your ammonia to drop so fast. That's a good thing. :D You didn't have to start over.
Need to know what kind of puffer you have? Click on Puffer ID.....Puffer ID: ug.php/v/PufferPedia/
What to feed your puffer? Click on Feeding......
Feeding: library/feeding/feeding-your-puffers/
Have a GSP, need more information......Click on GSP Article.....
GSP Article: library/puffers-in-focus/an-introductio ... d-puffers/
User avatar
liquid88
Figure 8 Puffer
Posts: 163
Joined: Thu Feb 12, 2009 2:43 pm

Re: Stress Coat+ and Ammonia

Post by liquid88 »

So LilGreen u would suggest to just leave the 10g alone and let the 29g cycle without the use of seed material from the 10?
User avatar
liquid88
Figure 8 Puffer
Posts: 163
Joined: Thu Feb 12, 2009 2:43 pm

Re: Stress Coat+ and Ammonia

Post by liquid88 »

edmlfc1 I wish it was so but as I originally thought it was the Stress Coat+ that caused the initial drop in ammonia levels. The tank has been fairly stable at 2-4ppm for the past day or two...slight progression but with the temp at only 77 degrees I doubt it will get back to where it was any time soon.
User avatar
LilGreenPuffer
Former Staff Member
Posts: 5301
Joined: Sun Jan 25, 2009 11:26 pm
Gender: Female
My Puffers: Dwarf puffer - Thumbelina (only mine in my heart now; she lives in CT with my friend)

RIP Inigo Montoya, Fezzik, and Vizinni.
RIP James Bond.
Location (country): United States
Location: Kentucky

Re: Stress Coat+ and Ammonia

Post by LilGreenPuffer »

liquid88 wrote:So LilGreen u would suggest to just leave the 10g alone and let the 29g cycle without the use of seed material from the 10?
I would, but I'm not an expert. Maybe someone else will know for sure.
"I will give you a talisman. Whenever you are in doubt, or when the self becomes too much with you, apply the following test. Recall the face of the poorest and the weakest man whom you may have seen, and ask yourself, if the step you contemplate is going to be of any use to him or her. Will she gain anything by it? Will it restore her to a control over her own life and destiny? In other words, will it lead to freedom for the hungry and spiritually starving millions? Then you will find your doubts and your self melt away."

Found among the papers of Mohatma Gandhi


Image

Come and visit http://www.thetriopsforum.com!

I AM A DUDETTE!

NEED NITRIFYING BACTERIA FOR YOUR NEW TANK? PM ME!
User avatar
liquid88
Figure 8 Puffer
Posts: 163
Joined: Thu Feb 12, 2009 2:43 pm

Re: Stress Coat+ and Ammonia

Post by liquid88 »

This is really weird...one site tells me that nematodes are harmless to fish but another acts as if they're the plague. If I was to dose the tank with something to get rid of them completely and then use gravel/filter media to seed the 30g I guess that could work theoretically. Any recommendations for a nematode cure?
User avatar
LilGreenPuffer
Former Staff Member
Posts: 5301
Joined: Sun Jan 25, 2009 11:26 pm
Gender: Female
My Puffers: Dwarf puffer - Thumbelina (only mine in my heart now; she lives in CT with my friend)

RIP Inigo Montoya, Fezzik, and Vizinni.
RIP James Bond.
Location (country): United States
Location: Kentucky

Re: Stress Coat+ and Ammonia

Post by LilGreenPuffer »

Umm... no. As I said, I'm not an expert. Wait for or message someone who is. Maybe Pufferpunk?
"I will give you a talisman. Whenever you are in doubt, or when the self becomes too much with you, apply the following test. Recall the face of the poorest and the weakest man whom you may have seen, and ask yourself, if the step you contemplate is going to be of any use to him or her. Will she gain anything by it? Will it restore her to a control over her own life and destiny? In other words, will it lead to freedom for the hungry and spiritually starving millions? Then you will find your doubts and your self melt away."

Found among the papers of Mohatma Gandhi


Image

Come and visit http://www.thetriopsforum.com!

I AM A DUDETTE!

NEED NITRIFYING BACTERIA FOR YOUR NEW TANK? PM ME!
Nick
Former Staff Member
Posts: 3231
Joined: Sun Oct 22, 2006 8:47 pm
My Puffers: Mine:
GSPs - Shakespeare and Jillybean
F8 - Velvet
My fiance:
DP - Emma Goldman
Narrow Lined Puffer - Ulrike
Location (country): Northeastern USA
Location: Middletown, CT
Contact:

Re: Stress Coat+ and Ammonia

Post by Nick »

Nematodes are such a broad class of worms, you can't label them good or bad. Parasitic types are bad, detrivores, which live on scraps of food, harmless.
No matter how magnificent your successes or devastating your failures, the worlds' approximately 5 billion impoverished people could not possibly care less.
User avatar
liquid88
Figure 8 Puffer
Posts: 163
Joined: Thu Feb 12, 2009 2:43 pm

Re: Stress Coat+ and Ammonia

Post by liquid88 »

The new heater has been running for 1 week now and the tank temp is 86. Ammonia levels are around 2-4ppm with 20 drops of ammonia added per day now instead of 40. Nitrite is between 2-3ppm. Changed substrate of 10g from gravel to pool filter sand and moved most of the gravel to the 29g in a pair of stockings.
There is alot of white "fluffy/slime" material in the tank, on glass, rocks, plants and inside the filter. What is this stuff?

When I add the the Stress Coat+ to the tap water during the large water change before I purchase fish; will it starve the established bacteria of ammonia?
Post Reply