I got rid of my bubble disks cause their was too many bubbles in the tank. Now i just need to know if this is enough surface movement in my tank for them to get plenty of oxygen..
The spraybar is the eheim one and the middle of the 3 attachments it pointing upward and the other two down...Do you guys think this is enough oxygen?
How else could I improve oxygen in a 38 gallon tank with sap's?
Thanks
Enough oxygen?
-
asianpuffer
- Figure 8 Puffer
- Posts: 229
- Joined: Fri Oct 23, 2009 3:52 pm
- My Puffers: 38 Gallon Tank
** 3 SAP's - Location (country): AZ
- J-P
- Former Staff Member
- Posts: 5626
- Joined: Tue Oct 13, 2009 12:21 am
- Gender: Male
- Location (country): Japan
- Location: Sasebo, Nagasaki, Japan
Re: Enough oxygen?
That looks good.
Why do you need to improve O2?
Plants? ( for some reason I feel like I am promoting planted tanks too much)
Why do you need to improve O2?
Plants? ( for some reason I feel like I am promoting planted tanks too much)
if you follow me, you avoid stepping in the crap that I just did...
https://www.youtube.com/channel/UCZR55G ... pqlgec1A2Q
https://www.youtube.com/channel/UCZR55G ... pqlgec1A2Q
-
asianpuffer
- Figure 8 Puffer
- Posts: 229
- Joined: Fri Oct 23, 2009 3:52 pm
- My Puffers: 38 Gallon Tank
** 3 SAP's - Location (country): AZ
Re: Enough oxygen?
J-P wrote:That looks good.
Why do you need to improve O2?
Plants? ( for some reason I feel like I am promoting planted tanks too much)
lol no reason just want to make sure my puffers are getting enough oxygen. So this would be enough? I was thinking about pointing all the tubes upward but then the bottom would not get any movement.
- J-P
- Former Staff Member
- Posts: 5626
- Joined: Tue Oct 13, 2009 12:21 am
- Gender: Male
- Location (country): Japan
- Location: Sasebo, Nagasaki, Japan
Re: Enough oxygen?
I can't say one way or the other.
I try to get as much surface movement as possible for 2 reasons:
1) it breaks up the film form feeding high protein foods and
2) it helps aerate the mater.
If you REALLY need more aeration you tap tube into the intake that will take in air and that spray bar will blow bubbles.
I try to get as much surface movement as possible for 2 reasons:
1) it breaks up the film form feeding high protein foods and
2) it helps aerate the mater.
If you REALLY need more aeration you tap tube into the intake that will take in air and that spray bar will blow bubbles.
if you follow me, you avoid stepping in the crap that I just did...
https://www.youtube.com/channel/UCZR55G ... pqlgec1A2Q
https://www.youtube.com/channel/UCZR55G ... pqlgec1A2Q
-
asianpuffer
- Figure 8 Puffer
- Posts: 229
- Joined: Fri Oct 23, 2009 3:52 pm
- My Puffers: 38 Gallon Tank
** 3 SAP's - Location (country): AZ
Re: Enough oxygen?
J-P wrote:I can't say one way or the other.
I try to get as much surface movement as possible for 2 reasons:
1) it breaks up the film form feeding high protein foods and
2) it helps aerate the mater.
If you REALLY need more aeration you tap tube into the intake that will take in air and that spray bar will blow bubbles.
do you think i could just point all of them upward and get a powerhead for the bottom for movement? would that be too much current?
- J-P
- Former Staff Member
- Posts: 5626
- Joined: Tue Oct 13, 2009 12:21 am
- Gender: Male
- Location (country): Japan
- Location: Sasebo, Nagasaki, Japan
Re: Enough oxygen?
Again I am no pro ( only recently acquired SAPs)... I hope someone chimes in there.
your set up is totally different than mine. I have a swivel powerhead that oscillates horizontally. This picks up some debris from the lower strata and distributed the water across the top.
In YOUR tank, what is powering that spray bar? My guess in an internal pump of some sort that will also act as a mechanical filter.
AFAIK SAPs like unidirectional movement. A current in only one direction. Understanding that, my set have already broken those rules.
So, I am in the same boat as you are. Filtration, chem, and mechanical I can do. Fish behavior ... beyond my pay grade
your set up is totally different than mine. I have a swivel powerhead that oscillates horizontally. This picks up some debris from the lower strata and distributed the water across the top.
In YOUR tank, what is powering that spray bar? My guess in an internal pump of some sort that will also act as a mechanical filter.
AFAIK SAPs like unidirectional movement. A current in only one direction. Understanding that, my set have already broken those rules.
So, I am in the same boat as you are. Filtration, chem, and mechanical I can do. Fish behavior ... beyond my pay grade
if you follow me, you avoid stepping in the crap that I just did...
https://www.youtube.com/channel/UCZR55G ... pqlgec1A2Q
https://www.youtube.com/channel/UCZR55G ... pqlgec1A2Q
-
asianpuffer
- Figure 8 Puffer
- Posts: 229
- Joined: Fri Oct 23, 2009 3:52 pm
- My Puffers: 38 Gallon Tank
** 3 SAP's - Location (country): AZ
Re: Enough oxygen?
J-P wrote:Again I am no pro ( only recently acquired SAPs)... I hope someone chimes in there.
your set up is totally different than mine. I have a swivel powerhead that oscillates horizontally. This picks up some debris from the lower strata and distributed the water across the top.
In YOUR tank, what is powering that spray bar? My guess in an internal pump of some sort that will also act as a mechanical filter.
AFAIK SAPs like unidirectional movement. A current in only one direction. Understanding that, my set have already broken those rules.
So, I am in the same boat as you are. Filtration, chem, and mechanical I can do. Fish behavior ... beyond my pay grade
hmm. yeah im new to this too.
The spraybar is powered by a eheim 2075 external cannister
- J-P
- Former Staff Member
- Posts: 5626
- Joined: Tue Oct 13, 2009 12:21 am
- Gender: Male
- Location (country): Japan
- Location: Sasebo, Nagasaki, Japan
Re: Enough oxygen?
IMO (and just mine) you are fine. Regular water changes and gravel cleaning should be enough to eliminate your worries about the lower strata.
Is your tank planted as of yet?
Is your tank planted as of yet?
if you follow me, you avoid stepping in the crap that I just did...
https://www.youtube.com/channel/UCZR55G ... pqlgec1A2Q
https://www.youtube.com/channel/UCZR55G ... pqlgec1A2Q
-
asianpuffer
- Figure 8 Puffer
- Posts: 229
- Joined: Fri Oct 23, 2009 3:52 pm
- My Puffers: 38 Gallon Tank
** 3 SAP's - Location (country): AZ
Re: Enough oxygen?
J-P wrote:IMO (and just mine) you are fine. Regular water changes and gravel cleaning should be enough to eliminate your worries about the lower strata.
Is your tank planted as of yet?
no but i really want to. I just barely got a huge mopani drift wood in there.
Dont know where to begin with real plants. subtrate, lighting, etc...
- J-P
- Former Staff Member
- Posts: 5626
- Joined: Tue Oct 13, 2009 12:21 am
- Gender: Male
- Location (country): Japan
- Location: Sasebo, Nagasaki, Japan
Re: Enough oxygen?
ahhhhh... I had that problem also...
and the same drift wood. Luckily I had Pro help. Mostly from here and from other sources.
viewtopic.php?f=7&t=19691&hilit=+500
if you skim that thread.. and ignore the BS you'll find some good info in there
and the same drift wood. Luckily I had Pro help. Mostly from here and from other sources.
viewtopic.php?f=7&t=19691&hilit=+500
if you skim that thread.. and ignore the BS you'll find some good info in there
if you follow me, you avoid stepping in the crap that I just did...
https://www.youtube.com/channel/UCZR55G ... pqlgec1A2Q
https://www.youtube.com/channel/UCZR55G ... pqlgec1A2Q