have i just poisened my puffs?
-
rachy
- Green Spotted Puffer
- Posts: 289
- Joined: Tue Jun 16, 2009 3:01 pm
- Gender: Female
- My Puffers: 4 adult dwarf puffers ( sugar, hamish, diddy + porky)
2 smallerDP's (squidge + speckle)
+ now 70+ baby DP's :)
7 south american puffers ( shaun, paddy, sketch,
pele + 3 with no name yet!)
2 irrubesco (princess ruby + richy) - Location (country): uk
- Location: north east uk
have i just poisened my puffs?
was just doing wc on 1 of my puffs tank, but when ive poured the fresh water into the tank, i can see loads of little blue n silver looking floaty bits. we just had a new boiler fitted 2 days ago, i im guessing it must b to do with that?? does anyone know what its likely to be?my bf is saying possibly bits of flux...which cant b good canit!!! ive taken water back out the tank, and now its at around 50% full...but i dont wanna even think about filling it with water from that hot tap until i know its safe!! if it is flux, what will this do to the puffers?
- Hilly
- Mentor
- Posts: 1903
- Joined: Sun Jan 15, 2006 6:36 pm
- Gender: Male
- My Puffers: Current: Tetraodon Lineatus
Previous:
Tetraodon Sabahensis
Montrete Abei
Tetraodon Biocellatus
Carinotetraodon Salivator - Location (country): UK
- Location: Nottinghamshire, UK
Re: have i just poisened my puffs?
Flux is paste, more likely going to be little bits of solder or wire wool shavings that have been used.I wouldnt imagine it will do them good but you have renmoved as much as you can quickly so thats good.. Just run your taps for a bit that should flush anything out of the new system.
Hilly
Re: have i just poisened my puffs?
I have no idea but if using cold water is safe you could always set it up so that cold water is siphoned into the tank via airline. With a good water turnover and your heater on that would probably be fine as long as you take breaks and monitor the temperature.
It is absurd to talk of one animal being higher than another. We consider those, when the cerebral structure/intellectual faculties most developed, as highest. A bee doubtless would when the instincts were.
Charles Darwin
Charles Darwin
-
rachy
- Green Spotted Puffer
- Posts: 289
- Joined: Tue Jun 16, 2009 3:01 pm
- Gender: Female
- My Puffers: 4 adult dwarf puffers ( sugar, hamish, diddy + porky)
2 smallerDP's (squidge + speckle)
+ now 70+ baby DP's :)
7 south american puffers ( shaun, paddy, sketch,
pele + 3 with no name yet!)
2 irrubesco (princess ruby + richy) - Location (country): uk
- Location: north east uk
Re: have i just poisened my puffs?
thanks you 2...the tap has been running now sincebefore i posted this, so hopefully be somewhere near cleared now lol!! but of course theres no hot water left lmao!! will leave it running for nother 10 mins or so, then ty again later whenwater heats back up
- Dadof4
- Tech Team
- Posts: 2862
- Joined: Sun Oct 19, 2008 5:50 am
- Gender: Male
- My Puffers: 1 GSP (Microfiche) RIP, 1 Monotrete Turgidus (Leon) in a 30gal. 1 Monotrete suvattii in a 40 gal FW. 120 gallon BW with 3 juvenile Dragon Gobies (so cool). 55 gal with a 2" GSP named Hank. 180 gallon being set up for a Fahaka in the next few months!
- Location (country): United States
- Location: North Wisconsin
Re: have i just poisened my puffs?
With new plumbing you need to turn it on and run it for about 5 minutes. Keep turning it off and on for a while (without the aerator on the faucet) and let it run for a short time each time.
It's more than likely not flux as it's very corrosive. It cleans corrosion and oxidation from the outer pipe surfaces to be soldered, prevents further oxidation, and helps the liquid solder basically make the two pipes one. You are more than likely see metal shavings or solder that dripped inside the pipe flowing from the tap as Flux is water soluble and flushes away from the inside of the pipe with the first run of water. Don't think you poisoned your puffs, just added a little silver and lead to their tank. As long as you remove the pieces you should be ok.
It's more than likely not flux as it's very corrosive. It cleans corrosion and oxidation from the outer pipe surfaces to be soldered, prevents further oxidation, and helps the liquid solder basically make the two pipes one. You are more than likely see metal shavings or solder that dripped inside the pipe flowing from the tap as Flux is water soluble and flushes away from the inside of the pipe with the first run of water. Don't think you poisoned your puffs, just added a little silver and lead to their tank. As long as you remove the pieces you should be ok.
"Darwin swings...annnnnnd a miss. Boy Jim, Chuck's suffered at the plate tonight. He's 0 for 3 and I'm not sure he's recovered from that shoulder pull a few weeks ago. I'll bet the front office is re-thinking that contract."
-
Nick
- Former Staff Member
- Posts: 3231
- Joined: Sun Oct 22, 2006 8:47 pm
- My Puffers: Mine:
GSPs - Shakespeare and Jillybean
F8 - Velvet
My fiance:
DP - Emma Goldman
Narrow Lined Puffer - Ulrike - Location (country): Northeastern USA
- Location: Middletown, CT
- Contact:
Re: have i just poisened my puffs?
blue and silver floaty bits... pieces of pipe/tank coatings or treatments, would be my best guess. Unlikely water soluble much, so if they're mostly cleaned out by changes the fish should be OK. Flux uses on pipe joints is a totally separate, invisible concern, but as stated above, just a bit of running the water will take care of it as well.
No matter how magnificent your successes or devastating your failures, the worlds' approximately 5 billion impoverished people could not possibly care less.