new 8x3x3!!!!
- flash.dan
- Green Spotted Puffer
- Posts: 433
- Joined: Fri Aug 22, 2008 9:50 am
- My Puffers: 8 years of FW puffer care!
currently have 1x mbu
Bubba 17" gentle giant... loves a belly tickle.
2x Suvatti Pair
1x Carinotetraodon borneensis - Location: Coventry, UK
new 8x3x3!!!!
well ive been looking at a project for the summer to move the cutiepie haha
ive decided on a 8x3x3 and found i can build one myself (tank only) for £372 out of 12mm float glass..... Usually i would of thought to of used toughened glass but as this required a sump drilling etc etc not possible...... but actually it is.... you can get drilled toughened glass.....
basically i spoke to a manufacturer round the corner and he informed me that toughed glass is just placed in a kiln. so it can be drilled before than then blasted so its 3x stronger and easier to handle AND HAS HOLES FOR A CLOSED LOOP SYSTEM........... I Almost wet myself! probably looking at over 500-600 mark for the glass....... stand ill throw together out of 2x4 and just clad it in pine.
I may have to pay more for the drilling and heating the glass but i think it will be well worth it. ill take a week to silicone the hell out of it and build a stand and bobs your aunties uncle!
more than likely the 6x2 that the pie is in at the min ill use that as a sump. for the 8x3
thinkjuly time
ive decided on a 8x3x3 and found i can build one myself (tank only) for £372 out of 12mm float glass..... Usually i would of thought to of used toughened glass but as this required a sump drilling etc etc not possible...... but actually it is.... you can get drilled toughened glass.....
basically i spoke to a manufacturer round the corner and he informed me that toughed glass is just placed in a kiln. so it can be drilled before than then blasted so its 3x stronger and easier to handle AND HAS HOLES FOR A CLOSED LOOP SYSTEM........... I Almost wet myself! probably looking at over 500-600 mark for the glass....... stand ill throw together out of 2x4 and just clad it in pine.
I may have to pay more for the drilling and heating the glass but i think it will be well worth it. ill take a week to silicone the hell out of it and build a stand and bobs your aunties uncle!
more than likely the 6x2 that the pie is in at the min ill use that as a sump. for the 8x3
thinkjuly time
- Jase
- Mbu Puffer
- Posts: 1579
- Joined: Sat Jan 12, 2008 3:13 am
- Gender: Male
- My Puffers: RIP Hootey :(
- Location (country): USA
- Location: Montana
Re: new 8x3x3!!!!
Sounds like a great project! I'm sure cutiepie will love it 
-Jase
edmlfc1 wrote:A house without a puffer is not a home.![]()
- puffertt77
- Suspended
- Posts: 822
- Joined: Thu Feb 05, 2009 8:19 pm
- My Puffers: Mbu Puffer named Naboo
South American Puffer named Bollo RIP :(
3 Dwarf Puffers yet to be named
Red Eye Red Tailed Puffer - Returned to LFS for being to vicious
Porky the Porcupine
Pup the Dogface - Location: London
Re: new 8x3x3!!!!
Hey Flashdanflash.dan wrote:''ive decided on a 8x3x3 and found i can build one myself (tank only) for £372 out of 12mm float glass''
''probably looking at over 500-600 mark for the glass''
That sound great, I cannot wait to see the pix
How much is it going to cost you £375 or £500/£600?
Also how are you going to hold the glas in place when you silicone it?
Will you make a wooden box and put the glass inside and silicone it?
- flash.dan
- Green Spotted Puffer
- Posts: 433
- Joined: Fri Aug 22, 2008 9:50 am
- My Puffers: 8 years of FW puffer care!
currently have 1x mbu
Bubba 17" gentle giant... loves a belly tickle.
2x Suvatti Pair
1x Carinotetraodon borneensis - Location: Coventry, UK
Re: new 8x3x3!!!!
300 if its float glass 500ish if i get it drilled then toughened. Just silicone it together its not overly big so will be fine. Ill put it together on site over a week or so
- puffertt77
- Suspended
- Posts: 822
- Joined: Thu Feb 05, 2009 8:19 pm
- My Puffers: Mbu Puffer named Naboo
South American Puffer named Bollo RIP :(
3 Dwarf Puffers yet to be named
Red Eye Red Tailed Puffer - Returned to LFS for being to vicious
Porky the Porcupine
Pup the Dogface - Location: London
Re: new 8x3x3!!!!
How will you hold the glass in place?flash.dan wrote:300 if its float glass 500ish if i get it drilled then toughened. Just silicone it together its not overly big so will be fine. Ill put it together on site over a week or so
- flash.dan
- Green Spotted Puffer
- Posts: 433
- Joined: Fri Aug 22, 2008 9:50 am
- My Puffers: 8 years of FW puffer care!
currently have 1x mbu
Bubba 17" gentle giant... loves a belly tickle.
2x Suvatti Pair
1x Carinotetraodon borneensis - Location: Coventry, UK
Re: new 8x3x3!!!!
silicone it... just like any other glass tank
-
pufferfreak
- Mbu Puffer
- Posts: 1012
- Joined: Sun Dec 16, 2007 10:26 pm
- Gender: Male
- Location (country): U.S.A.
- Location: San Siego, CA
- Contact:
Re: new 8x3x3!!!!
I think they mean like the frame for the tank, mine has a black frame.
- puffertt77
- Suspended
- Posts: 822
- Joined: Thu Feb 05, 2009 8:19 pm
- My Puffers: Mbu Puffer named Naboo
South American Puffer named Bollo RIP :(
3 Dwarf Puffers yet to be named
Red Eye Red Tailed Puffer - Returned to LFS for being to vicious
Porky the Porcupine
Pup the Dogface - Location: London
Re: new 8x3x3!!!!
flash.dan wrote:silicone it... just like any other glass tank
This is what I meant before about having a wooden box that you put the glass in and then silicone the tank together inside it and then turn it upside down to get the tank out when it's set
-
pufferfreak
- Mbu Puffer
- Posts: 1012
- Joined: Sun Dec 16, 2007 10:26 pm
- Gender: Male
- Location (country): U.S.A.
- Location: San Siego, CA
- Contact:
Re: new 8x3x3!!!!
I can't wait till this project is done though, i may have to make my own tank.
- flash.dan
- Green Spotted Puffer
- Posts: 433
- Joined: Fri Aug 22, 2008 9:50 am
- My Puffers: 8 years of FW puffer care!
currently have 1x mbu
Bubba 17" gentle giant... loves a belly tickle.
2x Suvatti Pair
1x Carinotetraodon borneensis - Location: Coventry, UK
Re: new 8x3x3!!!!
no if you get the glass in a frame first its difficult to silicone.... ill just use 100kilo clamps. on each corner top and bottom. can pick them up for about £20 each at most DIY stores then after 2 days to cure i will trim excess and bead the inside ive made about 10 tanks to date mainly for other people pretty easy as long as the glass is perfectly cut
-
Woodbutcher
- Figure 8 Puffer
- Posts: 121
- Joined: Tue Feb 24, 2009 9:08 pm
- Gender: Male
- My Puffers: Dogface puffer "Blondie"
- Location (country): USA
- Location: The mountians of Southern California
Re: new 8x3x3!!!!
Just trying to sort out the pictures in my head -- have 3 pics -- good thing the head is mainly empty.
Is the tank size in inches, feet or meters?
Is the tank size in inches, feet or meters?
The passage of time won't make you wise,but mistakes can. If you seek wisdom ------ try to use other peoples mistakes.
Woodbutcher
Woodbutcher- flash.dan
- Green Spotted Puffer
- Posts: 433
- Joined: Fri Aug 22, 2008 9:50 am
- My Puffers: 8 years of FW puffer care!
currently have 1x mbu
Bubba 17" gentle giant... loves a belly tickle.
2x Suvatti Pair
1x Carinotetraodon borneensis - Location: Coventry, UK
Re: new 8x3x3!!!!
feet..... only problem i will face that will be tricky is finding a home for cutiepie 7 acaras and about 50 other tetras etc whiile i move / sell 6x2xw2 and put a 8x3 in the same spot...... i think the bath will be out of action for a few days hahahah
shower round the neighbours!
shower round the neighbours!
- puffertt77
- Suspended
- Posts: 822
- Joined: Thu Feb 05, 2009 8:19 pm
- My Puffers: Mbu Puffer named Naboo
South American Puffer named Bollo RIP :(
3 Dwarf Puffers yet to be named
Red Eye Red Tailed Puffer - Returned to LFS for being to vicious
Porky the Porcupine
Pup the Dogface - Location: London
Re: new 8x3x3!!!!
lolflash.dan wrote:feet..... only problem i will face that will be tricky is finding a home for cutiepie 7 acaras and about 50 other tetras etc whiile i move / sell 6x2xw2 and put a 8x3 in the same spot...... i think the bath will be out of action for a few days hahahah
shower round the neighbours!
Does acrylic bond to glass?
I was wondering whether you could have a Acrylic front and glass bottom, sides and back
Also would 12mm be ok for 10ftx4ftx4ft?
Cheers mate
-
Woodbutcher
- Figure 8 Puffer
- Posts: 121
- Joined: Tue Feb 24, 2009 9:08 pm
- Gender: Male
- My Puffers: Dogface puffer "Blondie"
- Location (country): USA
- Location: The mountians of Southern California
Re: new 8x3x3!!!!
My LFS has taken in boarders in the past if you do business with him regular like. Maybe Your LFS may do the same?
Matter of fact he has my dogface puffer right now, he had quit eating and his eyes were clouding.
Matter of fact he has my dogface puffer right now, he had quit eating and his eyes were clouding.
The passage of time won't make you wise,but mistakes can. If you seek wisdom ------ try to use other peoples mistakes.
Woodbutcher
Woodbutcher- puffertt77
- Suspended
- Posts: 822
- Joined: Thu Feb 05, 2009 8:19 pm
- My Puffers: Mbu Puffer named Naboo
South American Puffer named Bollo RIP :(
3 Dwarf Puffers yet to be named
Red Eye Red Tailed Puffer - Returned to LFS for being to vicious
Porky the Porcupine
Pup the Dogface - Location: London
Re: new 8x3x3!!!!
Hey Flashdan
I've just got a really good quote on a 10ft w x 4ft h x 1inch think sheet of Acrylic
It's £588.00 plus VAT!
That may sound a lot but every other place I've tried has been over £900, one gave me a quote of £2000!
Here's the website and email address just in case you want to find out how much it'd be to make your fish tank:-
http://www.pure-plastics.co.uk
sales@pure-plastics.co.uk
I've just got a really good quote on a 10ft w x 4ft h x 1inch think sheet of Acrylic
It's £588.00 plus VAT!
That may sound a lot but every other place I've tried has been over £900, one gave me a quote of £2000!
Here's the website and email address just in case you want to find out how much it'd be to make your fish tank:-
http://www.pure-plastics.co.uk
sales@pure-plastics.co.uk