Page 1 of 1
When to start converting to BW
Posted: Wed Oct 19, 2011 3:04 pm
by Cheeto
HI everyone i have 2 small cyelon puffers about 1" 1.5" i know they are brackish puffer and i feel bad keeping them in 100% fresh water. so my question is when should/can i start to raise the salinity?
Re: When to start converting to BW
Posted: Wed Oct 19, 2011 3:11 pm
by sevenyearnight
When your tank, if it isn't right now, stable with its parameters. If newly cycled, wait at least a week or so. Start raising the SG by 0.002 a week.
*Edit, sorry I forgot some zeros, one really important one at that!
Re: When to start converting to BW
Posted: Wed Oct 19, 2011 3:59 pm
by RTR
+1 to seven's remarks, with one minor correction - the amount of specific gravity change per week is correctly written as 0.002 per week.
Re: When to start converting to BW
Posted: Wed Oct 19, 2011 7:16 pm
by Cheeto
okay so my tank is fully cycled i just wanted to make sure i wasnt adding salt to early
Re: When to start converting to BW
Posted: Fri Oct 21, 2011 12:04 am
by Cheeto
: ) okay let the fun begin! so i got a bucket of Instant Ocean sea salt and i know to start at 0.002 per week but hydrometer doesnt read that low i have a 20gallon tank and im struggling to figure out how much salt to add to get it around 0.002
Re: When to start converting to BW
Posted: Fri Oct 21, 2011 9:14 am
by sevenyearnight
Order one online. You can't do this process effectively without an accurate measurement.
Re: When to start converting to BW
Posted: Fri Oct 21, 2011 9:23 am
by bertie 83
+1 if your measurements are out you could risk damaging the bacteria in your tank, which will put you back to square one.
Re: When to start converting to BW
Posted: Fri Oct 21, 2011 9:44 pm
by Cheeto
okay so right my my SG 1.000 and salinity 0 acording to what i have read
viewtopic.php?f=5&t=19348 if i do a 50% waterchange with water at 1.004 SG it will raise my SG to 1.002? plz let me know if im right or wrong
Re: When to start converting to BW
Posted: Fri Oct 21, 2011 9:46 pm
by sevenyearnight
That is correct, assuming your readings are accurate.
Re: When to start converting to BW
Posted: Sat Oct 22, 2011 11:22 am
by RTR
And also assuming that your 50-% partial volumes are accurate.