DARN LUCKY!!!
Posted: Sun Aug 01, 2010 11:05 am
Today was my day to do a water change on my Ceylon/GSP tank. As it's a big tank, it usually takes me about 2 hours to do if I'm doing it by myself, which today I was.
I got all the way through, put water back into the tank and now time to turn the heaters back on. I have 2 heaters on that tank, one at each end. I plugged one in and then I went to plug the other in. A moment later, the electric went out, not all of it, but part of the house. Silly me did not put two and two together and I had the husband go and reset the electric again (mainly because it had happened a couple of times earlier in the week). This time, everything comes on and all seems fine. Then all the sudden, one heater literally explodes and all of the heating element came popping out!!!
First thing I thought of was were my puffers all right?! I looked into the tank and I seen one of the GSP's and I figured if that one was alive, then the others must be, and one by one I seen they were all okay. But that little episode scared the life out of me. I can only guess that the electric snapped off and that's why the puffers weren't electrocuted, and what's even stranger is that the glass tube that the heating element fits down into didn't break. All the stuff inside the tube came popping out, but the tube was completely intact. So I didn't have to worry about trying to get glass out of the tank.
The thing is, this heater came from a friend, and my friend lengthened the cord by splicing it into another cord and wrapping it together with electric tape. I'm sure most of you probably know better, but I didn't think anything bad of it. Now I will know better and will not use any electric items that have been modified, or spliced. I also think the heater was rated for 110 and we use 220 over here in the UK. So that's another bad thing about it. So I would advise anyone using any dodgy equipment to think again and remove it before you have any problems.
I can only think that luck was with me today and it could have been so much worse. I would have been devastated if I'd lost my puffers.
I got all the way through, put water back into the tank and now time to turn the heaters back on. I have 2 heaters on that tank, one at each end. I plugged one in and then I went to plug the other in. A moment later, the electric went out, not all of it, but part of the house. Silly me did not put two and two together and I had the husband go and reset the electric again (mainly because it had happened a couple of times earlier in the week). This time, everything comes on and all seems fine. Then all the sudden, one heater literally explodes and all of the heating element came popping out!!!
First thing I thought of was were my puffers all right?! I looked into the tank and I seen one of the GSP's and I figured if that one was alive, then the others must be, and one by one I seen they were all okay. But that little episode scared the life out of me. I can only guess that the electric snapped off and that's why the puffers weren't electrocuted, and what's even stranger is that the glass tube that the heating element fits down into didn't break. All the stuff inside the tube came popping out, but the tube was completely intact. So I didn't have to worry about trying to get glass out of the tank.
The thing is, this heater came from a friend, and my friend lengthened the cord by splicing it into another cord and wrapping it together with electric tape. I'm sure most of you probably know better, but I didn't think anything bad of it. Now I will know better and will not use any electric items that have been modified, or spliced. I also think the heater was rated for 110 and we use 220 over here in the UK. So that's another bad thing about it. So I would advise anyone using any dodgy equipment to think again and remove it before you have any problems.
I can only think that luck was with me today and it could have been so much worse. I would have been devastated if I'd lost my puffers.