Page 1 of 1
best API test kit
Posted: Wed Jun 30, 2010 11:39 pm
by briguy44
I was just making sure, I think that I read one here once when someone said that the freshwater version would be fine to use on brakish water. I have been raising the SG for my GSP's and have therefor been checking the water quality a lot to make sure I haven't screwed up the bacteria doing it. It seems to me that the ammonia test always comes out milky or cloudy. It is always yellow (0 ppm) but cloudy. I have tried it out on my freshwater tank and it always comes out a clear yellow. Is this just because of the salt in the brakish water making the test cloudy? Anyone else noticed this?
Re: best API test kit
Posted: Wed Jun 30, 2010 11:54 pm
by Pufferpunk
Yes, the salt will do that but the color should still work.
Re: best API test kit
Posted: Thu Jul 01, 2010 12:14 am
by Brandon8521
I noticed while raiseing my sg that, yes it became cloudy also that at about 1.010-014 it started to look more like the sw card rather then the fws bright yellow.
Re: best API test kit
Posted: Thu Jul 01, 2010 5:39 am
by soggydrysuit
Hi Bcummings8521,
That's bang on for the transition between fw and sw. Moderators have suggested the same. Basically to start using the marine card at s.g. 1.010
I said I'd produce some pics of different salinities and ammonia content using that API kit, didn't I?! I will, even if it's something I add to when I can

Re: best API test kit
Posted: Thu Jul 01, 2010 12:04 pm
by briguy44
Could I still use the freshwater test kit if I take them full marine? If not around where would be the cut off to switch to the marine test kit?
Re: best API test kit
Posted: Thu Jul 01, 2010 12:41 pm
by Pufferpunk
They're pretty cheap. Just purchase the SW ammonia test.