Page 1 of 1
filter help
Posted: Tue Jun 22, 2010 12:11 pm
by xrayjeeper83
Not sure where to post this so feel free to move it.
I have a marineland 220 on my 55(got it in a trade do plan on another hob filter) but my problem is that every now and then it seems to suck air from some where. If i move the filter it gets worse. Ive sat and shook it for like 3-4 mins and it still did it. so I dont think its air stuck in the filter.
Re: filter help
Posted: Tue Jun 22, 2010 3:35 pm
by Pufferpunk
Gotta be a leak in the tubing somewhere.
Re: filter help
Posted: Tue Jun 22, 2010 4:54 pm
by sao870
+1 for leak in tubing
Re: filter help
Posted: Tue Jun 22, 2010 5:02 pm
by xrayjeeper83
I checked that over but there is no water on the outside of any of the tubes
Re: filter help
Posted: Tue Jun 22, 2010 5:15 pm
by Pufferpunk
Even if water isn't coming out, air may be going in.
Re: filter help
Posted: Tue Jun 22, 2010 6:20 pm
by xrayjeeper83
have any suggestions to help find the spot?
Re: filter help
Posted: Wed Jun 23, 2010 12:28 am
by Ohyouknow
I'd say, a somewhat 'permanant' solution is if you can get a silicone sealant (aquarium safe) and seal up anywhere you have a connection. Of course, you won't be able to take it apart.....I don't know how expensive tubing is, if it can be replaced - just a thought.
Re: filter help
Posted: Wed Jun 23, 2010 1:26 am
by Dadof4
This is more than likely a leak in the "aquastop block" that goes in to the top, probably around the valves. I use the larger C-360 for one of my tanks and the C-530 on another and both have developed an air leak in that area. Never had it leak water though which is good. If you have an air leak on the intake tubing on these filters you can see it in the tubing usually. Another thing to try is to press down on the priming button that's on the top (just a little) and see if it mis seated after you primed it. They also sell seal ring kits for all the C series too. Marineland replaced both mine and I haven't had a problem since.
Re: filter help
Posted: Wed Jun 23, 2010 2:23 am
by xrayjeeper83
thanks for the info