Page 1 of 1

life of ceramic pellets?

Posted: Sat Jun 19, 2010 1:26 am
by briguy44
I just purchased me an AC 110 for my 55 gallon with my two gsp's and I was just reading the box and it said that you should change the ceramic pellet things every 3 months? Is this right? I was under the understanding that they lasted years and did a really great job of holding bacteria. If they don't last then could I just buy some other replacement ceramic things and put them in that last longer? Sorry to have to ask but I am still learning
(and still have a long way to go! :sorry:)

Re: life of ceramic pellets?

Posted: Sat Jun 19, 2010 1:56 am
by Nick
You can either clean them or replace them a few times a year. I just wash the crap out of them until the bag holding them breaks up, which takes 3-6 years or more. The theory under which they are replaced is that given enough time, organics films of various types reduce the effective surface area and thus they will hold less bacteria given time. If you are lazy, feel free to just replace, but just the same as if you clean them, make sure it's not within a couple weeks of replacing the sponges or other filter media.

Re: life of ceramic pellets?

Posted: Sat Jun 19, 2010 3:24 am
by briguy44
Oh okay that makes sense to me, thanks Nick.......Do the most of you all just stick with the stock foam, carbon, and ceramic or is there something better to use?

Re: life of ceramic pellets?

Posted: Sat Jun 19, 2010 4:19 am
by bigfatfish
I don't use carbon in my BW tank. I use the floss cushion stuffing (dead cheap) to remove any fine particles - works really well.

Re: life of ceramic pellets?

Posted: Sat Jun 19, 2010 1:27 pm
by RTR
There are two functions to the microporous ceramic or glass biomedia. The first is for nitrification, which is the oxidation of ammonia through nitrite to nitrate. This function and the bacteria which perform it are aerobic, so these biofilms are on the external surfaces only. The second function is denitrification, the reduction of nitrate to elemental nitrogen, which off-gases to the air. This function is anaerobic -it does not happen when significant oxygen is present, so occurs only in the deep micro-channels in the ceramic or glass.

The exterior surface good guy bacterial films shed and regenerate regularly and routinely, so can function indefinitely in biofilters. The microprous anaerobic channels however do clog from overgrowth and dead bacteria, and they cannot be successfully at home, or for practical purpose, anywhere else. So if the denitrifiction is important to you, you should replace about 1/3 of the biomedia every few months.

Personally, I consider denitrification a waste of effort in hobby tanks - we remove nitrate and many other undesirables with water changes, which is far better than denitrification alone. All of my biomedia are permanent, with indefinite lifespans for both the media and the bacterial colonies on it.

HTH

Re: life of ceramic pellets?

Posted: Sat Jun 19, 2010 1:52 pm
by Brandon8521
The only thing i buy for my AQ filters is the carbon when needed. I dont keep them in the filter but use them as needed for chemical and med removal. I replace them after a few uses since i dont know how long they actually work. But for the bio media i havnt replaced them as long as i have owned the filters and one i have had for about 5 years.

Re: life of ceramic pellets?

Posted: Sat Jun 19, 2010 4:59 pm
by xrayjeeper83
RTR what kinda media do you use?

Re: life of ceramic pellets?

Posted: Sun Jun 20, 2010 12:13 am
by Pufferpunk
AC comes with Bio-Max & I have been using the same ones in my filters for >20 years. Same sponges too! Never changed them out, just rinsed. Sounds like a great way for them to get you to buy more though.

Re: life of ceramic pellets?

Posted: Sun Jun 20, 2010 1:35 am
by briguy44
Right that's what i was thinking too. Kinda the same deal as the fish foods that say feed 2-3 times daily. I was pretty sure that really the only thing that needs to be changed often is carbon if you choose to use it. As always thanks for the information!

Re: life of ceramic pellets?

Posted: Sun Jun 20, 2010 10:11 am
by Myaj
The carbon actually turns itself into a rather nice bio filter as well, so if you put that in, feel free to leave it, just rinse like you would with the biomedia.

I use filter floss as well, and save the carbon for removing meds/chemicals, that sort of thing.

If you really want to clean out your biomedia, you can steam it clean in some boiling water, but never do it to all the media at once or you'll kill too much bacteria and risk a mini-cycle. I just rinse mine out and have for years.

Re: life of ceramic pellets?

Posted: Sun Jun 20, 2010 6:13 pm
by RTR
Biomedia:

In canisters I use Dupla Minikaskade spheres and have for decades. In W/Ds I use Dupla Biocascade spheres. Neither product is currently available in the USA SFAIK. It used to be available here, but now seems only to be common in Europe. It is self-cleaning and I have used these for decades.

In RFUG tanks I use I use inert smallish gravel for FW, or aragonite sand for brackish water.

In fluidized bed filters I use either tightly sized sand or synthetic resin grains, also tightlly sized..

Mechanical media:

Sponges of various porosities..

Chemical media:

Rarely used, water changes are general;y cheaper and much more broad-spectrum.

FWIW.

Re: life of ceramic pellets?

Posted: Sun Jun 20, 2010 8:26 pm
by omplmpa3
I use the AC filters as well. I don't use the carbon, that goes in my turtle's tub. I do add extra ceramics to all my filters, to have on hand just in case.