Page 1 of 2

Very bad return!?

Posted: Sun May 02, 2010 10:42 pm
by Brandon8521
Well I just got back from my 2 week drill with the gaurd. While I was driveing home I called my wife and talked to her, she was haveing the air conditioner cleaned and the duct work cleaned out. When I get home her and my daughter was outside because the smell of the chemicals was very strong. When I went inside I didnt smell chemicals I smelt burnt electrical cables. I ran to my 40 gallon brackish tank (i noticed nothing was running on it no filter no lights or anything) and good thing I had a breaker on the power cable because It was almost melted in half. The only thing I can think of is that the filter became clogged or something and it over ran, the water dripped down the cable and cause a meltdown/small fire on my power strip. So now I have a couple air pumps running in it and the filter media just sitting next to the airpumps to try and keep some sort of flow going through them so I can put them in the new filter i have to get tomorrow along with a new light strip, and heater cause all of the cable ends were completely melted. I hope Hiro my gsp will do ok till tomorrow. Oh and i have a couple burns on the carpet and the wall where the strip was has smoke damage. So im glad to be back home but man it wasnt pretty.

Re: Very bad return!?

Posted: Sun May 02, 2010 10:54 pm
by J-P
woah ... and no one noticed that?? a circuit overload?? and they didn't call you??

Re: Very bad return!?

Posted: Sun May 02, 2010 11:00 pm
by Brandon8521
Nope my wife is a complete bond at heart even though she is a brunette. They thought it was the chemicals the man was useing to clean out the ac and duct work. Even the guy doing it was dumbfounded and thought he had torched my ac unit.

Re: Very bad return!?

Posted: Sun May 02, 2010 11:04 pm
by J-P
that is crazy ... I am sorry ... something simple turns out so badly

Re: Very bad return!?

Posted: Sun May 02, 2010 11:05 pm
by SilasMortimer
I'd say you got back just in time. I really hope everything turns out okay.

Re: Very bad return!?

Posted: Sun May 02, 2010 11:13 pm
by Brandon8521
Yah im lucky I didnt come home to a pile of ashes. I think the sponges should at least hold enough bacteria to keep it cycled and maybe I will go through a small cycle when I get the new filter. I should be ok with the oxygen to, I hope. But pretty much im looking at all new gear for this tank and that sucks. Im not even going to try craigslist or anything I dont have the time first thing tomorrow I am heading to the lfs.

Re: Very bad return!?

Posted: Sun May 02, 2010 11:17 pm
by Mezzovex
can you just get some new ends from Home depot and rewire them? Ihate to see good lights and filters get thrown away because of bad ends. or is there more damage then that?

Re: Very bad return!?

Posted: Sun May 02, 2010 11:19 pm
by PolishPuff
WOW that was a close one MAN :shock:

Re: Very bad return!?

Posted: Sun May 02, 2010 11:21 pm
by SilasMortimer
If there's a local aquarist forum available to you, they probably have a classified section. You could post an emergency WTB thread and see if anyone can sell you the stuff you need cheaply. A lot of people have some extra stuff lying around and could use the cash. And you could save money that way.

I imagine there are plenty of bacteria in your substrate, as well, so it should cycle fairly quickly. Also, if you get a filter that uses the same media as your other tank, you could do some switching out.

Re: Very bad return!?

Posted: Mon May 03, 2010 11:26 am
by Brandon8521
I dont trust myself to re-wire the ends im really finicky with the electrical stuff. I am off to the lfs in a lil bit to get another set-up. The only thing i am thinking of trying to save is the light strip. I am going to take it apart in a lil bit to see how easily it would be to replace the whole cord. The filter i had was a aquaclear 50/200 so that shouldnt be to expensive at all.

Re: Very bad return!?

Posted: Mon May 03, 2010 12:07 pm
by Brandon8521
ok so i took the light assy apart and im not sure which end to hook up to the switch and which end to hook up to the im guessing negative which comes out of a little box. Which end is negative or positive on the end of the cord the fat one or the skinny one. i dont want to get it backwards and cause another fire.

Re: Very bad return!?

Posted: Mon May 03, 2010 12:23 pm
by SilasMortimer
Definitely better safe than sorry.

Re: Very bad return!?

Posted: Mon May 03, 2010 12:27 pm
by Ajepalmer
Bcummings8521 wrote:Nope my wife is a complete bond at heart even though she is a brunette. They thought it was the chemicals the man was useing to clean out the ac and duct work. Even the guy doing it was dumbfounded and thought he had torched my ac unit.
Gotta say it, "That's what you get from South Carolina....." i'm just playing though, but I've seen way to much of Jeff Foxworthy :P

Re: Very bad return!?

Posted: Mon May 03, 2010 12:32 pm
by Brandon8521
HAHA funny, yah she is a true southern carolina girl or at least the poster image of one lol. I love her though even though she can be dingy. Im still trying to figure out which cable i need to hook up to the switch. I know ima need a cord that distincuishes between neg and pos but not sure how to hook it up to the light itself. i could test it but i dont want to fry anything either.

Re: Very bad return!?

Posted: Mon May 03, 2010 7:21 pm
by Mezzovex
Bcummings8521 wrote:ok so i took the light assy apart and im not sure which end to hook up to the switch and which end to hook up to the im guessing negative which comes out of a little box. Which end is negative or positive on the end of the cord the fat one or the skinny one. i dont want to get it backwards and cause another fire.
its AC. There is no positive or negative. Dont risk it if you are not comfertable with doing it. better to be safe then sorry :D

its good that the filter isnt that expensive.