Page 1 of 2

dkh/gh for gsp's?

Posted: Wed Mar 24, 2010 9:29 pm
by Kungpaoshizi
I've only seen 1 place that mentioned alk/gh for gsp's...
And now I can't remember what it was, or find it...
I think it might have said medium to medium hard gh, and 9-12dkh?
Is that right?
Since I switched to the ro/di alk with salt is only ~4.25dkh....Much less than the tap was producing....:/
Wondered why they were kinda freakin out...well, at least 1 is..
Thanks~

Re: dkh/gh for gsp's?

Posted: Wed Mar 24, 2010 9:54 pm
by Dadof4
Have you been reconstituting the RO/DI before use? Your Kh/Gh will be low if your not.
http://www.fosterandsmithaquatics.com/p ... catid=4128

Re: dkh/gh for gsp's?

Posted: Thu Mar 25, 2010 8:51 am
by Nick
I've never bothered to use RO/DI water for my FOWLR GSP tank. There doesn't seem to be any nitrates or other wastes in the tap water here.

Re: dkh/gh for gsp's?

Posted: Thu Mar 25, 2010 8:56 am
by Kungpaoshizi
Dadof4, that looks like it's more for FW, mine is BW atm...
Let alone I could just get some dkh buffer etc

And ya Nick, I totally didn't want to use ro/di cause tap would be much cheaper, but I've got 70-80ppm trates straight from the tap... :(

I'm really just wondering if anyone knows what the proper alkalinity is and/or hardness, needed for Green Spotted Puffers?

Re: dkh/gh for gsp's?

Posted: Thu Mar 25, 2010 9:01 am
by Nick
They prefer water with lots of dissolved carbonates. It's not known exactly just how much carbonate hardness, but what you get from a good marine mix when making high brackish to marine water is known to be enough. You could use instant ocean "reef crystals" salt mix for extra carbonates if you are concerned. I don't recall if you've mentioned, what SG is your GSP in?

Re: dkh/gh for gsp's?

Posted: Thu Mar 25, 2010 11:16 am
by Kungpaoshizi
Instant Ocean is what I've been using~
They're at 1.011 right now...

I've got aragamax sand (carib sea) as a substrate...

But I just want to make sure I've got enough of a buffer but even more so, I just want to make sure I've got the appropriate water parameters for a gsp...

And what I said earlier about the site with the only info I've found, it was hardness, not alkalinity, so I've found 0 resources for a degree of alk.... Everyone else just says ph, and that's very valid, but I would think alkalinity would make a difference as well other than JUST for 'how much of a buffer'...

Re: dkh/gh for gsp's?

Posted: Thu Mar 25, 2010 11:44 am
by Pufferpunk
1.011 isn't enough salt to replace the minerals removed with RO. Add the reconstituting product or use tap.

Re: dkh/gh for gsp's?

Posted: Thu Mar 25, 2010 12:36 pm
by Kungpaoshizi
I've been using this
http://www.fosterandsmithaquatics.com/p ... catid=4017

Am I still missing minerals besides what's in here?

Re: dkh/gh for gsp's?

Posted: Thu Mar 25, 2010 12:54 pm
by Pufferpunk
This is the wrong product. You need what Dad linked.

You don't need that at all for a tank. All the essential elements needed for a reef tank is in the salt. Waste of $$$, IMO.

Re: dkh/gh for gsp's?

Posted: Thu Mar 25, 2010 1:20 pm
by Kungpaoshizi
Awesome, they actually have some here at a store!
So until I get to what SG do I need to use this stuff? Prolly 1.02ish?

I would just use tap, but I hate to use tap since that's what I got the ro/di for :P

Thanks btw everyone :)

Re: dkh/gh for gsp's?

Posted: Thu Mar 25, 2010 1:29 pm
by Nick
I'd guess around 1.016 or so.

Re: dkh/gh for gsp's?

Posted: Thu Mar 25, 2010 1:57 pm
by Kungpaoshizi
I don't get it....
Kent Marine Essentials:
Inorganic mineral salts of aluminum, boron, bromine, calcium, chromium, cobalt, copper, iodine, iron, lithium, magnesium, manganese, molybdenum, nickel, potassium, selenium, sulfur, strontium, tin, vanadium, and zinc

Kent RO Right:
A perfect mix of salts and trace elements to balance RO and deionized water, including calcium, sodium, potassium, and magnesium

No Sodium with the KME, buuuuuut.... this stuff doesn't even touch on alkalinity buffering if I'm reading all this right?

Re: dkh/gh for gsp's?

Posted: Thu Mar 25, 2010 4:40 pm
by Pufferpunk
All it does is replace the minerals removed from the water with RO filtration.

Re: dkh/gh for gsp's?

Posted: Thu Mar 25, 2010 5:12 pm
by Kungpaoshizi
I understand what it does, but still what's the dkh and dgh that green spotted puffers REQUIRE.. :P

From what I can tell, the ro right, is still more for fresh water than anything else...
The marine essentials contain all of the same from the ro right, minus kh buffers, and electrolytes...
The salt would provide the gh then? (I've tested it and I can't say that 1450 tds is NOT contributing to general hardness?)
Also I assume the salt provides electrolytes, since you've said before:
Re: 63$ 0 ppm RO/DI
by Pufferpunk on Mon Mar 08, 2010 10:09 pm

What are you planning on keeping in this tank? If fish only, then all you need is salt & aragonite sand, for minerals & a steady pH of around 8. Nothing more. Live rock is always a good idea too.
____________________________________________________________________________________________________

So back to my original tidbit of what SHOULD the dkh be, to get my current setup, back to what they require..

I don't wanna have to buy another product if I don't have to...

Re: dkh/gh for gsp's?

Posted: Fri Mar 26, 2010 11:17 am
by Kungpaoshizi
/bump
Nobody knows what the gh/dkh are supposed to be for GSP's?