Page 1 of 1

Help needed

Posted: Wed Feb 24, 2010 9:45 am
by garrysmith
I have just testedc my water:-

PH - 8
Amonia - 0
nitrate - 30
nitrite - .8

Yesterday i started the cycle of changing from fresh to brackish which it only raised just over .001

I am about to do a further 50% change, shall i add salt or just FW?

Re: Help needed

Posted: Wed Feb 24, 2010 10:48 am
by garrysmith
ok, i have just changed 50% of the tank and will do again tomorrow

Re: Help needed

Posted: Wed Feb 24, 2010 10:56 am
by garrysmith

Re: Help needed

Posted: Wed Feb 24, 2010 10:58 am
by PolishPuff
Its only safe to raise SG by .002 per week

Re: Help needed

Posted: Wed Feb 24, 2010 10:59 am
by J-P
Have you read this section?
Cycling, Specific Gravity, Acclimating
library/puffers-in-focus/an-introductio ... d-puffers/

Re: Help needed

Posted: Wed Feb 24, 2010 11:17 am
by Flutter
He only raised it 0.001 though...

Re: Help needed

Posted: Wed Feb 24, 2010 11:25 am
by garrysmith
having done the 50% water change the reading is now just under .002, I am going to do another 50% tomorrow so would i then need to mix the new water to .002 to keep it at the same level?

I suck at mathes lol

Re: Help needed

Posted: Wed Feb 24, 2010 11:31 am
by PolishPuff
Flutter wrote:He only raised it 0.001 though...
yeah, but he was thinking of doing another 50% w/c and adding salt

Re: Help needed

Posted: Wed Feb 24, 2010 11:33 am
by jus85411
might have just had some bacteria die off. raising .002/week will help minimize the bacteria die off as new bacteria forms. when you go to raise it next week, test the salinity, if it says 1.002 then add the water you have mixed and aerating. make sure to monitor the water with salt in it as it will take a little bit of time for the full salinity to show as it gets mixed better in the water. but you want the main tank after the second addition of salt water to be at 1.004

Re: Help needed

Posted: Wed Feb 24, 2010 11:37 am
by garrysmith
so if im gonna do a 50% change every day to get the levels down in the nitrite do i just mix the new water at 1.002 every time to keep the tank at 1.002?

Re: Help needed

Posted: Wed Feb 24, 2010 11:54 am
by Flutter
Yes.

Re: Help needed

Posted: Wed Feb 24, 2010 12:26 pm
by Pufferpunk
I would not raise the SG at all, until the parameters are stable for at least a week or 2.