Fishless Cycling Hardness Dilemma
Posted: Mon Jan 25, 2010 12:20 am
Hey again, so today is the beginning of the second week since I began the “re-cycling” of the tank. Just to recap the story, my brother had an overstocked 10 gallon tank that I “salvaged.” I removed the gravel in it (It was extremely dirty and full of planaria) and I cleaned all the sides (Full of diatoms/brown algae. Considering the fact that he had the tank up since March of 09, that’s not good..) I left about 20% of the water that day and I just rinsed the filter clean a bit. (I’m not sure if that restarted the cycle and if it did I would be ok with it) Right now I’m trying to stabilize the tank so I could put two or one DPs in it. The readings of Ammonia before that 80% water change on the 17th were above 7.5. The Nitrates were at 160 and the Nitrites at 3. So that water change was very well needed! I kind of didn’t keep record of the readings I took daily, but the water change did help a lot as I could remember. Today I did a 50% water change, and the readings are…
Ammonia - .5-1
Nitrate - <20
Nitrite - <1
Ph – 6.0
KH – 40
GH – 0
Temp - 78F
I’m not really familiar with water chemistry, but I read the fishless cycling article in the puffer library (reffed by LilGreenPuffer) and I’m a bit worried about the KH level and how it will affect the cycling of the tank (Since it is fishless.) “This process is unlikely to go smoothly in low alkalinity/KH water. If the KH is not at or above 3 degrees (or ~50ppm), it should be monitored closely and adjusted. A pH crash is a very real and even likely occurrence, to the detriment of the colonies.” Sooo I would really appreciate some advice on how the KH and GH would affect the cycling progress and if I have to do something about it, and if so how? I'm a bit concerned about the ph too, I heard that DP's "like" fairly soft to slightly hard water (I'm not sure what the numerical values on these would be though. I have a feeling that 6 would be on the soft side.)
Also I’d like some advice on substrate for my future puffer tank. I heard sand was a good choice, and I’ve been window shopping (online if it’s possible lol) and I hear that sand gets really cloudy or is hard to manage, do you guys have any input on that? Good vs. bad sand?
-Thanks in advance guys! I really appreciate it : )
Ammonia - .5-1
Nitrate - <20
Nitrite - <1
Ph – 6.0
KH – 40
GH – 0
Temp - 78F
I’m not really familiar with water chemistry, but I read the fishless cycling article in the puffer library (reffed by LilGreenPuffer) and I’m a bit worried about the KH level and how it will affect the cycling of the tank (Since it is fishless.) “This process is unlikely to go smoothly in low alkalinity/KH water. If the KH is not at or above 3 degrees (or ~50ppm), it should be monitored closely and adjusted. A pH crash is a very real and even likely occurrence, to the detriment of the colonies.” Sooo I would really appreciate some advice on how the KH and GH would affect the cycling progress and if I have to do something about it, and if so how? I'm a bit concerned about the ph too, I heard that DP's "like" fairly soft to slightly hard water (I'm not sure what the numerical values on these would be though. I have a feeling that 6 would be on the soft side.)
Also I’d like some advice on substrate for my future puffer tank. I heard sand was a good choice, and I’ve been window shopping (online if it’s possible lol) and I hear that sand gets really cloudy or is hard to manage, do you guys have any input on that? Good vs. bad sand?
-Thanks in advance guys! I really appreciate it : )