Page 1 of 1
Filtration issue
Posted: Tue Dec 22, 2009 11:03 am
by Dadof4
Just lost all faith in my Marineland C series filters. Went to bed last night and tank looked fine, woke up this morning to gasping dragon gobies and mollies floating everywhere. Sometime during the night the Aqua Block that the hoses connect to snapped a piece and shut off the flow. I tested water and came up with ammon. 4, nitrates 0. Didn't bother with the nitrites, don't have the end product. This is the second time I've had issue with this filter, first time cost me a ton of money. I now need to build an emergency filter...thank goodness I have a GSP at the same SG.
Re: Filtration issue
Posted: Tue Dec 22, 2009 11:10 am
by PolishPuff
OH NO,so sorry, I was about to post a question asking if Marineland filters are worth the money?
Re: Filtration issue
Posted: Tue Dec 22, 2009 12:19 pm
by Dadof4
Depends. I've had good ones and bad ones.
Re: Filtration issue
Posted: Fri Dec 25, 2009 3:06 am
by Pufferpunk
I'll go Hagen Aquaclear any day, over Marineland.
Re: Filtration issue
Posted: Wed Dec 30, 2009 8:36 pm
by Eager Newbie
Sorry if I missed this, but did you move your filter build thread or did you just delete it? I searched but I can't find it any more.
Re: Filtration issue
Posted: Wed Dec 30, 2009 10:43 pm
by Dadof4
My camera died and the thread sat idle too long so I killed it. I am going to restart it tonight, I hate letting posts sit like that because they can get moldy....
Re: Filtration issue
Posted: Thu Dec 31, 2009 1:27 am
by Eager Newbie
Lol nice analogy. Def. looking forward to this, as I'm a fan of DIY projects. Tip: reserve a couple posts after your first one and then edit them later if you want to keep things tidy. XD
Did you end up using activated carbon in your filter? I hate the expensive custom made cartridges you have to live with for so many filters. I might build my own as well, looking for inspiration from you

Re: Filtration issue
Posted: Thu Dec 31, 2009 1:53 am
by Dadof4
Actually activated carbon is pretty much useless in a filter after 24 hours. The only time I use it is after I've had to use meds of some sort, then only to get rid of them.
Re: Filtration issue
Posted: Thu Dec 31, 2009 9:49 am
by RTR
Minor clarification: Every material adsorbed by activated carbon has its own saturation point. The time to saturation will depend on the particular material, its possible saturation point, the concentration in the tank, and the flow rate through the filter and carbon. One type of thing may have saturated the carbon, while others are still being adsorbed.
But I do agree that carbon to me carbon is not worth the cost in most cases. Water changes are cheaper and broader spectrum. When you do a 50% partial, you remove 50% of everything dissolved in the water, period. Do another partial and you get 50% of what was left behind the first time.