Page 1 of 1

impeller replacement?

Posted: Thu Jul 30, 2009 11:52 pm
by Dsmdan95
How often / when do you replace your impeller in your filter? I have a Fluval plus 3 internal filter. The filter is a little noisy but no too bad. It still works and everything but when I take it apart to clean it, the impeller comes off the shaft and I put it back on and it works fine. Should I replace it or just leave it be?

Re: impeller replacement?

Posted: Fri Jul 31, 2009 12:39 am
by Pufferpunk
If it's noisy, the hole may have gotten distorted & getting a new shaft may not help. I replace them when sand gets caught bad enough that the magnet is ruined. Are you sure there is a rubber end holding it in place?

Re: impeller replacement?

Posted: Fri Jul 31, 2009 1:37 am
by Dadof4
On the Fluval series canisters the shaft is ceramic and is known to wear and they sell replacement shafts along with a shaft replacement tool. I'll look to see if I can find where to get them from.