Page 1 of 2
Help? Brackish setup for GSP
Posted: Thu Jul 23, 2009 10:12 pm
by nickel422
I have been going through so much information on how to set up a brackish water system for GSP and still confused. I currently have a 40 gallon tank with two GSP in it. It has been fresh water system for about 3 months and 1 month with the GSP in them. So i am asking what would be the best way to bring up the freshwater to a brackish water system using red sea salt? I dont want hurt or shock the fish. I would appreciate the help

(And yes i am planning on getting a larger tank for the two of them.)
Re: Help? Brackish setup for GSP
Posted: Thu Jul 23, 2009 10:37 pm
by LilGreenPuffer
Increase the specific gravity by .002 per week, NO FASTER, with your weekly water changes. Do 50% changes. The first batch should be 1.004, so the result in the tank is 1.002. The next would be 1.008, so you'd get 1.004 in the tank... and so on. Keep going until you're where you want to be.
You'll need a hydrometer or refractometer for the measuring.
Re: Help? Brackish setup for GSP
Posted: Fri Jul 24, 2009 12:13 am
by Pufferpunk
![welcome [welcome]](./images/smilies/welcome.gif)
Glad you found us! Be sure to read the GSP artricle in our Library. I'm moving this to BW puffers.
Re: Help? Brackish setup for GSP
Posted: Fri Jul 24, 2009 3:49 pm
by nickel422
I guess my new question is: How much salt to add each week to approximated desired level of salt conditions? Tbs to gallon or cups of salt to gallon? Or is there a nifty chart to approximate the salt being added? I guess it varies too due to water changes too? Any suggestions?
Re: Help? Brackish setup for GSP
Posted: Sat Jul 25, 2009 1:23 am
by Pufferpunk
No nifty chart, just a very rough estimate. Best bet is to get yourself a hydrometer that starts at FW levels (1.000). Very roughly, it takes around a cup of marine salt to raise the SG of 5g of water by .005. Some math is involved here but since you won't want to raise it more than .002/week, that would be a little less than 1/2 cup/5g. Premixing overnight is best & be sure to check the Sg after tank is salted.
Re: Help? Brackish setup for GSP
Posted: Sun Jul 26, 2009 4:21 pm
by nickel422
Thanks everyone for the help!
Re: Help? Brackish setup for GSP
Posted: Sun Jul 26, 2009 11:31 pm
by Pufferpunk
Did you find a hydrometer?
Re: Help? Brackish setup for GSP
Posted: Tue Jul 28, 2009 11:46 pm
by nickel422
Yeah i did, I actually had one come with my 75g cichlid tank that i purchased from a guy selling his tank and equipment. The marineland instant ocean hydrometer. I really dont know if i trust it considering, the fact that our tap water reads around 1.002 on the hydrometer. Maybe i am using this simple device wrong? I might purchase a refractometer instead. Any thoughts or reveiws on the refractometers?
Re: Help? Brackish setup for GSP
Posted: Tue Jul 28, 2009 11:59 pm
by LilGreenPuffer
Most hydrometers read a bit off. You just have to account for that when you mix your saltwater.
Re: Help? Brackish setup for GSP
Posted: Wed Jul 29, 2009 12:09 am
by mrgreen
My hydrometer keepts reading at zero and I KNOW there's salt in there.
Re: Help? Brackish setup for GSP
Posted: Wed Jul 29, 2009 12:20 am
by LilGreenPuffer
Check the tap water, mrgreen.
Re: Help? Brackish setup for GSP
Posted: Wed Jul 29, 2009 12:36 am
by mrgreen
I think I will. It HAS read 1.002, but the last w/c I did was a 50% and I didn't add salt to the new as I was afraid I had too much salt in there to start.
Re: Help? Brackish setup for GSP
Posted: Wed Jul 29, 2009 12:51 am
by mrgreen
Just tested it. Was quite a bit above the zero line. Then I tested my tank. Its not much different.
Re: Help? Brackish setup for GSP
Posted: Wed Jul 29, 2009 12:57 am
by Pufferpunk
Exactly how much salt are you adding to what size tank?
Re: Help? Brackish setup for GSP
Posted: Fri Aug 07, 2009 2:08 pm
by lilacamy931
Asking on this salinity as real near the finish line on GSPs. So get them put in freshwater, allow to settle and raise salinity by 0.002
So have large tub, refractometer, marine salt and tapwater.
Put water and dechlornator in, add salt and measure using refractometer till .004. Leave overnight for the salt to dissolve properly in the water, double check salinity in the morning and then do the actual water change of 50% out and 50% in? Does this sound about right? One thing do need to ask, does the tub of water with salt in need to be heated overnight at tank temperature to ensure correct salinity as heat changes this?
Sorry to ask here, but thought pointless to raise another one and hope have main points.