Page 1 of 2

Suggestions Needed

Posted: Sat May 23, 2009 1:04 pm
by Dadof4
OK, so I made a decision. With the economy the way it is, and me not working a full schedule, I won't have the spare cash to put up my 180 gal SW tank. Instead, I am going to get the Fahaka I have always wanted and put it in there! The question I have is what filter would you guys recommend for a tank this big with a puffer this big? I am currently looking at an Ocean Clear 340 but I'm not sure about what pump I'd have to buy or how to plumb it. Ideas? Suggestions? Certificates of insanity? Nuggets of wisdom? I'd appreciate any of them!

Re: Suggestions Needed

Posted: Sat May 23, 2009 1:13 pm
by edmlfc1
I would get the largest size used aquarium to fit under my stand that I could find and make it into a sump. :D
A couple of baffles, a hang on the side sock, one large return pump and a sponge. Good to go. :wink:

Re: Suggestions Needed

Posted: Sat May 23, 2009 1:14 pm
by edmlfc1
Forgot about overflow box and hoses. :redface:

Re: Suggestions Needed

Posted: Sat May 23, 2009 1:28 pm
by yunachin
I use a Wet/Dry on Kaisers tank. It's manufactured by Chin. :D

Re: Suggestions Needed

Posted: Sat May 23, 2009 1:59 pm
by Dadof4
So, basically, just set up like a sump with out the skimmer and use more mechanical media?

Re: Suggestions Needed

Posted: Sat May 23, 2009 2:22 pm
by Sponge bob
Marine Land MAGNUM

Re: Suggestions Needed

Posted: Sat May 23, 2009 2:29 pm
by edmlfc1
Dadof4 wrote:So, basically, just set up like a sump with out the skimmer and use more mechanical media?
You might have to set it up as a wet/dry since it's fw. Then you can use bio media, platic pot scrubbers, lava rock (for a few ideas) to grow your good bacteria on. I actually made one with a bucket and a rubber maid tub. :D Only problem is that it won't fit under Annabelle's tank. I ended up using a canister until I can get a better stand.

Re: Suggestions Needed

Posted: Sat May 23, 2009 2:36 pm
by lilgirlkat
I wish I had some helpful advice, but i don't.. so.. good luck!!

I'm stoked for you!

Re: Suggestions Needed

Posted: Sat May 23, 2009 2:43 pm
by edmlfc1
Found some of the pictures. These are when I was going to use it for the sw, then I decided to use it for the fw instead. I turned the aquarium into a sump and got a rubbermaid tub for my wet/dry. Of course the tub wouldn't fit either. :(


The glue ($3-$4 can't remember)
Image

The hoses I made (2-5' each with pvc pipe for a fitting and hose clamps on each end approx $30) You can get cheaper hose.
Image

Turned a lid into a drip tray, hubby let me play with the drill. :D
Image

Used a piece of egg crate for the bottom of the bucket:
Image

Drilled holes at the bottom of the bucket and all around the sides.
Image

Put some egg crate under the bucket so that the water could drain and the bucket would not be touching the bottom and get clogged. Also used the second top cut two large holes out added 2 elbows into the holes to attach the blue hose for draining.
Image

My plan was to put from the bottom up in the bucket:
round eggcrate
bio balls
red lid with holes
filter floss
lid with elbows (lid screwed back on bucket)

My homemade overflow pipes:
Image

They worked
Image

Don't know what the gph rate was, so I couldn't tell you. If I ever get a tub in just the right size I will be trying this out on Annabelle's tank. :D

Re: Suggestions Needed

Posted: Sat May 23, 2009 2:50 pm
by Dadof4
OK, I've done a little searching and the 5 gallon bucket method seems to be my best option. If I use two buckets will I still need to aim for the 10x per Hr flow rate?

Re: Suggestions Needed

Posted: Sat May 23, 2009 3:15 pm
by edmlfc1
All you really need is one bucket. The more flow the better, even if you just add power heads to get a good current in the tank.



Edit: Sorry that don't make much sence. I would shoot for the 10x turnover but if you want more flow add powerheads. I think that's better. :lol:

Re: Suggestions Needed

Posted: Sat May 23, 2009 3:47 pm
by Dadof4
Excellent edmlfc1! Thanks for the help! The DIY way will end up saving me some cash and give me a nice project packed in to one!

Re: Suggestions Needed

Posted: Sat May 23, 2009 3:53 pm
by yunachin
That is fantastic! Better than my rig for sure.

Re: Suggestions Needed

Posted: Sat May 23, 2009 3:57 pm
by Dadof4
How did you do yours?

Re: Suggestions Needed

Posted: Sat May 23, 2009 4:35 pm
by yunachin
I don't have pictures like edmlfc does but I can try to describe it.
I have a 40 breeder divided in half with egg crate stacked to create an area for the bio-balls. Then more egg crate with a plexiglass top and insert for the hose. I run an Aqua Clear 50 which does about 250 gph running return. I keep a good water flow in there. ;) My tank is drilled so I did not make an overflow. If I feel like wedging under the tank I will take some pictures for sure. :D