Page 1 of 1

strength of water

Posted: Sun May 03, 2009 5:55 am
by RedPeasant
I am just curious, do puffers prefer hard or soft water?

Re: strength of water

Posted: Sun May 03, 2009 6:30 am
by LilGreenPuffer
Depends on the puffer. SW puffers prefer hard water; FW puffers prefer soft. I think brackish puffers also like hard water. Check the PufferPedia for a species-by-species breakdown. Of course, it often doesn't matter for FW puffers. They may be more likely to breed or something given the proper ph (that's pure speculation on my part there), but they're fine with it being off. My DPs do well in 8.4, even though the Pedia says something like 6.5, and the gurus have actually discouraged me from changing it, since fluctuations are worse for the fish than a steady not-perfect reading.

Re: strength of water

Posted: Sun May 03, 2009 9:29 am
by Bogwoodbruce
Yepp. Depends on sp.Marine species are going to want very hard water, usually 8+. Whereas some of the fresh and brackish species will vary, take the mbu for example when they come from the congo, up at the top is very soft, whereas down at the bottom with the rapids its very hard. This applies to several other species and genus of fish such as hydrocynus. so puffers will adapt to a large range of water parametres

Re: strength of water

Posted: Sun May 03, 2009 11:29 am
by Pufferpunk
When it comes to pH, puffers adapt, as Bruce said.

Re: strength of water

Posted: Sun May 03, 2009 1:00 pm
by RedPeasant
Which means I don't really have to bother much about it then. Right?

Re: strength of water

Posted: Sun May 03, 2009 1:06 pm
by LilGreenPuffer
Correct, unless it's insane, like 5 or something.

Re: strength of water

Posted: Sun May 03, 2009 2:00 pm
by Bogwoodbruce
You dont want to mess around usuing chemicals to help change PH, seen it go wrong for people too many times. I prefer to do it naturaly, like adding bogwood, and almond leaves etc for softer water and calicum based rocks for harder water