Page 3 of 4

Re: Puffers are everywhere...

Posted: Thu Jul 01, 2010 12:28 pm
by soggydrysuit
Dr. Monks idea about using a fridge for chilling is very welcome news to me.

Reef chillers are just not designed to 'pull down' temp by more than 2-3C or 10F very roughly. Just not enough power.

Stick a freezer on it 8)

I've been thinking about fridges and freezers to cool aquaria for about ten years on and off. Never took a power drill to a fridge before, though. I might try to look at what I was drilling through first :lol:

Nice one, Dr. Monks

...

Re: Puffers are everywhere...

Posted: Thu Jul 01, 2010 12:31 pm
by soggydrysuit
I mean, I might actually try to drill a hole in a fridge :lol:

An old one under controlled conditions: My wife and I own this house...

:)

Re: Puffers are everywhere...

Posted: Thu Jul 01, 2010 12:37 pm
by soggydrysuit
T. ocellatus, I'm moderately sure I've seen them stream past a camera, somewhere, somewhen. A doucumetary.

?

Re: Puffers are everywhere...

Posted: Thu Jul 01, 2010 1:31 pm
by CarmenH
That would be cool to see them in their natural habitat.

soggydrysuit wrote:T. ocellatus, I'm moderately sure I've seen them stream past a camera, somewhere, somewhen. A doucumetary.

?

Re: Puffers are everywhere...

Posted: Thu Jul 01, 2010 3:02 pm
by Ohyouknow
soggydrysuit wrote:I mean, I might actually try to drill a hole in a fridge :lol:

An old one under controlled conditions: My wife and I own this house...

:)
Drilling a hole in a fridge is doable; In fact, I know someone who did this in their 'party barn' in which they had a beer pong table and a the fridge - which would hold a keg, a hole drilled in the front - once you close the door, you could attach the tap, which was like a pull-tap at a bar... and would keep the keg cold, and easily accessed for the consumers. I'd be wary of drilling through the sides, however the door should be hallow (unless it has an outside dispenser) and no interfering wires. I'd assume most of the wires would be contained to the back anyhow; central to the specific cooling units and fans.

Re: Puffers are everywhere...

Posted: Thu Jul 01, 2010 3:44 pm
by pufferpuggirl
Pardon me for being stupid here ..... but I don't get how drilling a refrigerator is going to cool off an aquarium. Of course, I didn't read the aforementioned article on cooling off either .... so maybe someone can just explain quickly and easily what we're talking about here? :huh:

Re: Puffers are everywhere...

Posted: Thu Jul 01, 2010 4:15 pm
by xrayjeeper83
My thoughts would be drill a whole in the side, feed a tube through and run water through the fridge allowing the fridge to cool the water down before it exits

Re: Puffers are everywhere...

Posted: Thu Jul 01, 2010 4:29 pm
by pufferpuggirl
Ah, I see ..... seems like that would be expensive to run, but I have no idea how much an aquarium chiller costs in the first place, so maybe it's a good alternative. However, over here in the UK, I wouldn't think you would need to run something like that very often, if at all. Even with the temperatures being rather high this week, I've not had any problems with my tanks being abnormally high in temperature.

Re: Puffers are everywhere...

Posted: Thu Jul 01, 2010 4:37 pm
by xrayjeeper83
if you have some old fridge your not using it would be rather cheap to run

Re: Puffers are everywhere...

Posted: Thu Jul 01, 2010 4:45 pm
by pufferpuggirl
This is England, nothing is cheap over here! :)

Re: Puffers are everywhere...

Posted: Tue Jul 06, 2010 7:41 am
by soggydrysuit
Sorry, just got back to this thread after following the other recent T. ocellatus link.

Fridges:- !

I need to chill a 5g water bath at work here down to 5C for at least a working day at a time and I'm not supposed to use a commercial lab chiller to do this. If possible. We did have two chiller units that cost UKP 3000 but the ends of the cooling loops had corroded before I arrived in this post and are therefore inoperable.

Ice does work but it's not so effective. I've tried an ice/salt mixture of 50/50 in weight but not enough of it so I have a valid reason to mess about with fridges or freezers.

In a month or so I could be reporting on how a bucket of ice/salt in a standard freezer will work on some serious 'pull down'. I have an power meter I can use to measure the energy used.

Anyone interested?!

We're on about a 20 deg C 'pull down' on something approaching aquarium size...

Aquarium chillers are, I believe, designed to 'pull down' about 5C on your twig farm...

Re: Puffers are everywhere...

Posted: Tue Jul 06, 2010 7:49 am
by soggydrysuit
If this works, I can just see myself at home:-

I'd watch 'Evil Dead II' or something and get the hammer drill out :lol:

Sorry, dear, just fish tank stuff... :lol:


But only on the freezer bought for the purpose and I'd be going in through the door on the top of a 'chest' version...

Re: Puffers are everywhere...

Posted: Tue Jul 06, 2010 8:00 am
by soggydrysuit
It may be quite tricky, technically, to get some sort of thermostatic control in place.

I was thinking of an external thermostat that I could reverse...

And maybe turn the freezer to the highest temp possible, so the pipes to the tank don't freeze. Ice/salt but maybe not 50/50 w/w.

Not quite as simple as first thought.

BTW, 'buy a chiller' may not be an answer but you are all most welcome to comment :)

Re: Puffers are everywhere...

Posted: Tue Jul 06, 2010 8:17 pm
by J-P
The DIY chillers I have seen are all bar fridges with a bucket of water in them. The top is drilled and the hose is fed through and coiled in the bucket and then fed back out. You'd have to get a "frost free" one to do it. Trust me.. go frost free! Defrosting 6" of ice in not pleasant.

Re: Puffers are everywhere...

Posted: Wed Jul 07, 2010 8:57 am
by soggydrysuit
Now there's a good tip J-P, thanks :)