Page 2 of 2

Re: Water change / filter question

Posted: Sat May 22, 2010 12:45 am
by asianpuffer
Pufferpunk wrote:I find as long as the water level doesn't go below the intake tube while the filter is on, I don't need to prime it before turning it on. otherwise, just turn off the filter during the WC & turn it back on after the tank is full. I have all my filters plugged into a strip, so I can just flip a switch to turn them off & on. To prime the Eheim, you must fill to the top with water.
DO i fill the tubes to the top with water or the cannister?

Re: Water change / filter question

Posted: Sat May 22, 2010 12:52 am
by Pufferpunk
Just the canister, same as after you clean it, to get it started. Shouldn't be necessary unless the siphon broke, by letting the water level get below the intake.

Re: Water change / filter question

Posted: Sat May 22, 2010 2:48 am
by asianpuffer
Pufferpunk wrote:Just the canister, same as after you clean it, to get it started. Shouldn't be necessary unless the siphon broke, by letting the water level get below the intake.

directions from eheim says not to fill the cannister at all...?

Re: Water change / filter question

Posted: Sat May 22, 2010 3:06 am
by Pufferpunk
Not the way the 2 I have but they're both >10 years old.