Page 2 of 3

Re: Oxygen Help

Posted: Sun May 09, 2010 11:54 pm
by asianpuffer
Mezzovex wrote:does the issue stop after a while? i know on my 125g system when i turn off the pump it sucks water down till the water level reaches my vacume break hole. once that happens and i turn my pump back on, it has to purge out the air, resaulting in tiny bubbles...
no it does it consistently

Re: Oxygen Help

Posted: Sun May 09, 2010 11:55 pm
by Mezzovex
gasket leak on the filter lid?

Re: Oxygen Help

Posted: Sun May 09, 2010 11:55 pm
by asianpuffer
Mezzovex wrote:gasket leak on the filter lid?
AS far as i know there are no leaks...

Re: Oxygen Help

Posted: Sun May 09, 2010 11:57 pm
by asianpuffer
should i be repriming the filter after i turn it off and back on from feeding them?

Re: Oxygen Help

Posted: Sun May 09, 2010 11:58 pm
by Mezzovex
i would only think if it gets air in it...

Re: Oxygen Help

Posted: Mon May 10, 2010 12:24 am
by Pufferpunk
The air has to be leaking in somewhere.

Re: Oxygen Help

Posted: Mon May 10, 2010 6:53 am
by Nick
If the spray bar is above the water level it will always create bubbles. Try placing it below the water line, pointed slightly upwards, to create ripple without bubbles.

Re: Oxygen Help

Posted: Mon May 10, 2010 12:06 pm
by Pufferpunk
It sounds to me like the bubbles are coming out of the spray bar. Am I correct?

Re: Oxygen Help

Posted: Mon May 10, 2010 12:52 pm
by asianpuffer
Pufferpunk wrote:It sounds to me like the bubbles are coming out of the spray bar. Am I correct?
Yes the bubbles are coming from the spraybar.

The bar is fully submerged under the water and I cant find any where the air leak is coming from

Re: Oxygen Help

Posted: Mon May 10, 2010 12:59 pm
by Pufferpunk
Look again. Take the entire thing apart & check every gasket that they are seated properly, with no cracks in them.

Re: Oxygen Help

Posted: Mon May 10, 2010 1:43 pm
by asianpuffer
Pufferpunk wrote:Look again. Take the entire thing apart & check every gasket that they are seated properly, with no cracks in them.

Ok will do. I been seeing alot of other people on other forums having this same issue.

Re: Oxygen Help

Posted: Mon May 10, 2010 7:28 pm
by asianpuffer
Ok so I rechecked all hosed and clamps and gaskets and did not find anything. I reprimed the xp3 and still got bubbles. See the video...

Re: Oxygen Help

Posted: Mon May 10, 2010 9:31 pm
by J-P
Try some plumbers Teflon tape (yes I love that stuff) on the seals and see if that helps at all. Or the el-cheapo method is to use some petroleum jelly and do each seal one at a time. Only those above water. Make sure you use a generous amount. You may have a pinhole leak.

Re: Oxygen Help

Posted: Tue May 11, 2010 2:58 am
by SammyDee
+1

Re: Oxygen Help

Posted: Tue May 11, 2010 8:20 am
by asianpuffer
havent tried the jelly yet..

anyone know what could be causing white debris coming out from the spraybar as well?