Page 2 of 2

Re: Is my tank cycled?

Posted: Sat Nov 21, 2009 6:44 pm
by bigfatfish
Obviously the ammonia should be 0. Did the nitrite levels rise & then drop to 0, or have they always been 0?

Re: Is my tank cycled?

Posted: Sat Nov 21, 2009 8:38 pm
by asianpuffer
well i am not sure about that because the person at the lfs told me not to worry about checking the levels during the cycle. So i had the tank running with 4 mollies then 2 months later i checked the water to see if it was cycled and hey all read 0 so i stuck 3 saps in the tank with them. that is until i found out my kit was defective.
I removed the 4 mollies and did a 50% WC and those were the readings..

Re: Is my tank cycled?

Posted: Sun Nov 22, 2009 7:52 am
by bigfatfish
Well, you would hope after that time that the tank was cycled. But if it was, then your ammonia would be 0 - especially after removing the mollies. I think you need to keep up with large water changes until the reading is 0. Water changes will not remove much of the good bacteria because its mostly in the filter media etc. You could cut down on feeding, to minimise waste products for a few days too.

Re: Is my tank cycled?

Posted: Sun Nov 22, 2009 12:10 pm
by asianpuffer
I will try that. I was going to do another water change after 3 days of the first WC but i thought it would be a bad idea.

also does anyone know if there is any added benefits if I were to have 2 AC 70 HOB on my 38 gallon tank?

I currently have 1 AC 70 and a hydrosponge. does the hydrosponge have any benefits or should I get rid of that?

Thanks

Re: Is my tank cycled?

Posted: Sun Nov 22, 2009 1:21 pm
by asianpuffer
ok i just tested the water again:
0 nitrites
0 ammonia
10 nitrate

Should i do another WC even though I just did one 2 days ago?

Re: Is my tank cycled?

Posted: Sun Nov 22, 2009 2:12 pm
by bigfatfish
I wouldn't. Just check the ammonia/nitrite regularly.

Re: Is my tank cycled?

Posted: Sun Nov 22, 2009 3:12 pm
by LilGreenPuffer
How big were the mollies, and how big are the SAPs? I don't think that mollies create anything near the bioload of the puffers...

Re: Is my tank cycled?

Posted: Sun Nov 22, 2009 3:26 pm
by asianpuffer
the mollies were all around 3/4 inch but no longer in the tanks. The 3 SAPS are just about an inch long.

ANyone know if there is any added benefits for me adding another AC 70 in my 38 gallon tank?
Also i have a sponge filter in with my current AC70. Do i need this really?